After I place a snipe and see it in my Current list, how do I check the timing I have selected or change it from, say, 10 seconds to 3 seconds.
Thanks
Brian Burke

Hello Brian,
Thank you for your question about changing a lead time. You can change the lead time by adding the snipe again. It will replace the value set previously.
Currently, the lead time isn't shown in either of the views. We'd like to add it, but information is packed pretty tight into those views. As a result of your post, we're going to take another look at this to see if there's a way to add it into the next release. Keep an eye on the blog for progress. :)
Thank you for taking the time to write us. We welcome any follow-up comments or further suggestions you may have.